Resets the digital miner allows for the config to be accessed again and re-scans the area for new blocks after hitting the start button. If the indication is on, you will need to supply the shown block or else the miner will not continue to mine. Indicates if blocks are needed to replace mined ones. This does not need to be used if power is provided externally through one of its energy ports. Insert a source of energy (like a charged Energy Tablet or Energy Cube) to power the digital miner. This button will be unavailable to click once the start button has been pressed, the reset button must be pressed to allow access to the config interface. The miner will need to be reset for it to re-scan the area for new blocks.īrings up the config interface (see GUI below). It will NOT scan the area for any blocks/items placed after the start button was pressed. Upon running for the first time after being placed or reset, it will scan the area for the desired blocks. warded zones from Thaumcraft, shielded areas from RFTools etc.) by directly accessing the block, it cannot break unharvestable blocks or redstone.įor more detailed information, read the sections below. If you are unsure of anything, try testing the desired item/block first (ores should always be safe to mine).Įven though it can bypass obstacles (e.g. It is not recommended to use the digital miner to break items of high importance (machinery/altars) without first testing what effects it can cause (worst case being the item breaks without it dropping and not appearing in the Digital Miner's inventory). Up to 8 can be used for a 10x effect for both upgrades. To increase the energy capacity and efficiency of the miner, install energy upgrades. To speed up the miner, use speed upgrades. from a bin (mod equivalent of a container). by Logistical Transporter (mod equivalent of an item pipe) and the one on the top front to insert replacement blocks, i.e. The Digital Miner has two IO-Slots (indicated by a yellowish-tan square), the one on the back, where the items can be picked up, i.e. Once powered and your filters made, hit the Start button back in the main interface to start mining. If you do not wish to leave empty spaces where ore blocks used to be, fill the block replacement slot with any block, turn on the requirement in the filters, and supply the necessary blocks in the machine's inventory. In the main interface, click on the gray Config button to specify the area and filters for him to use. It can be powered through its energy slot (see GUI below) or by one of its three energy ports (indicated by a green square), which are situated on the sides and bottom. To begin, the Digital Miner needs a source of power.
0 kommentar(er)
